Magneti Plast

How to fit a shower cubicle?

Installing a shower cubicle can be a rewarding DIY project, transforming your bathroom into a modern and functional space. Here’s a comprehensive guide to help you fit your shower cubicle efficiently and safely.

Materials and Tools Needed

  • Shower cubicle kit
  • Drill and appropriate bits
  • Spirit level
  • Screwdriver
  • Silicone sealant and applicator gun
  • Measuring tape
  • Pencil
  • Safety gear (gloves, goggles)

Step 1: Plan and Prepare

  1. Check the Contents:
    • Ensure you have all the parts and fixtures according to the manufacturer’s instructions.
    • Inspect for any damage that might have occurred during delivery.
  2. Prepare the Area:
    • Clear the bathroom space where the cubicle will be installed.
    • Ensure the walls and floor are clean, dry, and free from any obstacles.

Step 2: Mark the Position

  1. Measure and Mark:
    • Use a measuring tape to determine the exact position of the shower cubicle.
    • Mark the positions of the wall profiles (or brackets) on the wall using a pencil.
  2. Check for Level:
    • Use a spirit level to ensure your marks are perfectly vertical and horizontal. This is crucial for a proper fit.

Step 3: Install the Wall Profiles

  1. Drill Holes:
    • Drill pilot holes into the wall where you’ve marked the positions for the wall profiles. Ensure you use the correct drill bit for your wall type (e.g., masonry, tile, or drywall).
  2. Fix Wall Profiles:
    • Align the wall profiles with the drilled holes and secure them using screws and wall plugs provided in the kit.

Step 4: Assemble the Shower Cubicle

  1. Base Tray (if applicable):
    • Place the shower tray in position and ensure it is level. Adjust the feet if necessary.
    • Seal the tray edges with silicone sealant and allow it to set according to the manufacturer’s instructions.
  2. Fit the Panels:
    • Depending on your cubicle type, you may need to assemble the glass panels or fit pre-assembled units into the wall profiles.
    • Carefully lift the glass panels into place, ensuring they are correctly seated in the profiles.
  3. Secure the Panels:
    • Attach the panels to the wall profiles using the provided screws or clips. Make sure everything is tight and secure.

Step 5: Install the Door

  1. Fit the Hinges/Rollers:
    • Attach the door hinges or rollers to the door panel according to the instructions.
    • Position the door on the cubicle frame and secure it.
  2. Adjust and Test:
    • Ensure the door opens and closes smoothly. Adjust the hinges or rollers if necessary for a perfect fit.

Step 6: Seal and Finish

  1. Apply Silicone Sealant:
    • Use silicone sealant to seal all joints and edges where the cubicle meets the walls and base tray.
    • Smooth the sealant with a tool or your finger dipped in soapy water to ensure a neat finish.
  2. Clean and Inspect:
    • Wipe away any excess sealant and clean the glass panels.
    • Inspect the entire installation to ensure there are no leaks or loose fittings.

Step 7: Allow to Set

  • Allow the silicone sealant to cure fully, usually 24 hours, before using the shower.

Safety Tips

  • Always wear safety gear when drilling and handling glass.
  • Follow the manufacturer’s instructions closely for best results.

By following these steps, you can successfully fit a shower cubicle, enhancing the functionality and aesthetics of your bathroom. Enjoy your new shower space!

Leave a Comment